Dakota Digital BIM-01-2-J1939, Manual

Page: 3 / 12

[3] MAN #650695
VFD3 Setup Continued:
Obtaining RPM from the BIM-01-2-J1939
•
Hold the SW1 switch from the instrument system control box while turning the key on.
o
The speed display should show

and the message display should show SETUP .
•
Release SW1. Tap SW1 until

and
TACH
are displayed.
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The displays should show 
and
T CAL
.
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The speed display will show the current
setting.
•
Tap SW1 until

and
BUS
are displayed.
•
Press and hold SW1 until
“-” and
DONE
are displayed.
•
Tap SW1 until

and
DONE
are displayed.
•
Press and hol
d SW1 until “-” and
DONE
are displayed.
Obtaining engine temperature from the BIM-01-2-J1939
•
Hold the SW1 switch from the instrument system control box while turning the key on.
o
The speed display should show

and the message display should show SETUP .
•
Release SW1. Tap SW1 until

and
WATER
are displayed.
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The displays should show 
and
SENDER
.
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The speed display will show the current
setting.
•
Tap SW1 until

and
BUS F
(Fahrenheit) is displayed.
o
Tap SW1 once more for

and
BUS C
(Celsius) if desired.
•
Press and hold SW1
until “-” and
DONE
are displayed.
•
Tap SW1 until

and
DONE
are displayed.
•
Press and hold SW1
until “-” and
DONE
are displayed.
Obtaining oil pressure from the BIM-01-2-J1939
•
Hold the SW1 switch from the instrument system control box while turning the key on.
o
The speed display should show

and the message display should show SETUP .
•
Release SW1. Tap SW1 until

and
OIL
are displayed.
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The displays should show 
and
SENDER
.
•
Press and hold SW1 for at least 3 seconds, until
 changes to “-”. The speed display will show the current
setting.
•
Tap SW1 until

and
BUS
are displayed.
•
Press and hold SW1 until “-” and
DONE
are displayed.
•
Tap SW1 until

and
DONE
are displayed.
•
Press and hold SW1 until “-” and
DONE
are displayed.
***Intake/manifold air temp, ambient air temp, air fuel ratio, trans fluid temp, fuel pressure, oil temp and boost will be displayed in the message center if
activated through the display menu setup.