MAN 650067:G
5
GAUGE SYSTEM FEATURES
Mileage readings
•
Million mile odometer
•
Two (A/B) re-settable trip odometers (0-9999.9)
•
Re-settable service countdown odometer (0-9999)
Performance readings
•
High speed recall. This is automatically reset at power up or can be manually reset.
•
High RPM recall. This is automatically reset at power up or can be manually reset.
•
0-60 mph (0-100kmh) time
•
¼ mile time
•
¼ mile trap speed. This is reset when the ¼ mile time restarts.
Hour meter
•
Resettable hours (0-999.9)
English/metric conversion
•
Alternate speed can be displayed on message display.
Special tachometer displays
•
On systems that do not have bar graph displays, a bar tach can be shown on the
message display.
•
On systems that do not have a digital tachometer display, the rpm can be shown on the
message display or the tachometer reading can be switched onto the speed display.
Built-in Indicators
•
Left/Right Turn signal indicators
•
High Beam indicator
•
Check Engine indicator
•
Brake Warning indicator
•
4x4 indicator
•
Wait to Start indicator
•
Cruise Control indicator
•
Gear Position indicator which displays full gear word with use of Dakota Digital GSS-
2000 (Purchased separately)
Special outputs
•
Shift output to activate external light
•
Selectable 2000ppm or 4000ppm speed output for cruise or ECM (not available when
using BIM-01-1 for speed)
Demonstration mode
•
Holding Switch 2 while turning on the key will start the system going through a preset
sequence of readings. To exit the demo mode, turn the key off. You may also wire up a
separate switch to power the gauges for demo mode without powering the entire vehicle.
Auxiliary gauge readings in tach message display with expansion bus interface modules (BIM)
(purchased separately).
