MAN 650067:G
16
Setting up the control box
Below is a list of all of the setup menus. You must have SW1 wired to enter setup;
descriptions of each menu are below. Pay close attention to Setup Menus and settings as
incorrect settings will cause faulty readings on the displays.
Main Menu
Sub Menu
Description____________________
SPEED
SENDER (NORMAL, BUS)
Select sensor type
AUTO
Auto calibrate speed
ADJUST
Adjust the speed calibration
SERVICE (OFF, 500 – 7500)
Select the service countdown
OUTPUT (2k PPM, 4k PPM)
Select output speed signal PPM setting
DONE
Exit setup menu
TACH
T CAL
(BUS, 1 – 16
))))
Set engine cylinder count
UPDATE (SLOW,
MID, FAST)
Set rpm update rate
WARN (2200 – 14800)
Set rpm shift warning point
SIGNAL (5 LO, 12 HI)
Select rpm signal voltage level
DONE
Exit setup menu
VOLT
WARN (10.0 – 13.1)
Set low volt warning point
DONE
Exit setup menu
WATER
SENDER (DD F,DD C,BUS F, BUS C)
Select sensor type
WARN (150-300F / 65 -148C)
Set high temp warning point
TEST
Display sensor ohm reading
DONE
Exit setup menu
OIL
SENDER (NORMAL, BUS)
Select sensor type
WARN (5 – 36)
Set low pressure warning point
TEST
Display sensor ohm reading
DONE
Exit setup menu
FUEL
SENDER (SW 33, CUSTOM,
Select sensor type
GM 30, GM 90, GM 250,
F 10, F 150, V 180, BUS)
CUSTOM
Calibrate custom fuel sensor
TEST
Display sensor ohm reading
DONE
Exit setup menu
PERF
On
On
On
On
Enable performance readings
Off
Off
Off
Off
Disable performance readings
NIGHT
Change preset night dimming
BIM
SCAN
Check/scan for connected modules
SETUP
Enter setup (only when modules present)
DONE
Exit setup menu
INFO
SE
SE
SE
SE
xx
Current software code on speed display
SPEED CAL PPM on press/hold
GEAR
OVRDRV
Will show gear position with overdrive at the
bottom of message center
NONE
No gear position shown
PRND21
Will show gear position at bottom of Message center
-ODOM
Used to preset odometer reading
To enter the setup mode, press and hold SW1 while turning the key/power on. The display
should light up and show
SET
SETUP on the speedometer and speed message displays.
Release the switch and
SET
SPEED
should display, this is the start of the setup menus. Press
and release SW1 to advance through the main menus. A press and hold will enter the sub
menu. A press and hold is also used to save the setting and jump to the next option, or exit a
menu when DONE is displayed.
