GB
80
Fixing the detector on a swivel bracket
1.
Hold the back plate against the wall in the desired
position and mark where to drill the holes.
2.
Drill the holes in the wall.
3.
Insert the long screw via the back plate and fasten
the plate to the wall.
4.
Put the back plate cover in place.
5.
Assemble both parts of the swivel.
6.
Insert the mounted swivel into the long screw.
7.
Position the base of the motion detector (a picture of
a man shows the top of the detector).
8.
Tighten the screws lightly in order to be able to adjust
the direction of the motion detector.
9.
Place the motion detector on its base and turn it so
that it is facing the right way.
Pin n° 0
for swivel
bracket
fixing
(factory-
mounted pin)
Pictogram
2 fixing
screws
Pre-drilled holes
Pictogram
Pin n° 1
for
fixing the
detector flat
against
the
wall
Fixing the detector flat against the wall
1.
Drill through the two pre-drilling holes in the base of
the motion detector.
2.
Place the base against the wall in the desired place in
order to mark where to drill the holes (a picture of a
man indicates the top of the base).
3.
Drill the holes in the wall and fix the base.
4.
Remove the factory-positioned pin.
5.
Detach pin n° 1 from the selection supplied.
6.
Position the pin in the right place.
7.
Place the motion detector on its base.
Summary of Contents for 173-21X
Page 1: ...upgraded for e Nova applications...
Page 16: ...86...
Page 17: ...87...
Page 18: ...805493 A 03 2013...
