DAITEM 173-21X, Installation Manual

Page: 5 / 18

GB
75
2. Programme the device as follows
3. Programming
Programming enables the detector
to be recognised by the control
panel.
1. To programme the detector the
control panel must be in
installation mode
. If it is not, ask
the user to press:
then:
master code
installer code
IMPORTANT: during recognition
programming, the product to be
programmed for use with the control
panel does not need to be placed next
to it. In fact, we recommend you place
the product at a short distance from
the control panel (at least 2 meters
away).
IMPORTANT: the control panel indicates
there is an error by emitting 3 short
beeps. When this happens programming
should be carried out again.
10 s max.
Press
‹
then # on the
control panel
keypad
Press
and hold the
“test” button
until
the control
panel
responds
The control panel waits
for a group to be chosen
(from 1 to 8 ). Choose the
groups by pressing the
corresponding numeral
on the control panel
keypad
The control panel waits
for the time delay to be
chosen. 0: immediate
1: delayed • 0: combined .
The time delay is chosen
by pressing “0” or “1” on
the control panel keypad
The control
panel gives a
voice message
to confirm
then
to
“détecteur X” “group?” “time delay?”
“beep, detector X,
group Y immediate
(or delayed or
combined)”
Example: programming of 1st detector allocated to Gr. 2 with immediate triggering.
10 s max.
)
)
)
)
then
“detector 1” “group?” “time delay?” “beep, detector 1
group 2,
immediate”
to
* according to
the model of the
control panel.
*
)
)
)
)
)