LineFit Light-LED (LFL-LED)
Installation Guide
3
Wire AC line to LED driver(s) in accordance with the
applicable local, state, and country electrical codes.
Connect black to black or brown, white to white or
blue, and green to green using 18 AWG (0.82mm
2
)
wire connectors.
Add up total footage of the system to determine the
appropriate number of 24VDC Class 2 Tetra
®
LED
drivers to use based on the Power Supply Loading
chart on last page.
Connect the red stripe wire (+) of the LED system to
the red wire (+) of the power supply. Connect the white
wire (-) of the LED system to the black or blue wire (-) of
the power supply.
Connect Line Fit Lights using twist-on wire connectors or in-line (IDC) connectors. Join white wires together and red
striped wires together. Cap all exposed wires with appropriate end caps or apply electric grade (non-corrosive) silicone for
additional weather protection.
NOTE: Make sure not to exceed LED driver power limits (see Step 1). Drawing above is for reference only; your lighting layout may differ.
NOTE: All electrical connections should be suitably protected from mechanical damage and the environment. Seal all connections in
locations that may be exposed to water with electrical grade RTV silicone.
AC line
GEPS24-180
NOTE: All drivers except GEPS24-180U must be installed in a raceway or be provided with a GEPSJB60 LED driver extended enclosure.
If installing multiple LED drivers, keep them at least
2” (50.8mm) apart end to end and 4” (101.6mm)
apart along the sides.
AC line
Black to black
or brown (-)
Green to green
White to white
or blue (+)
Power supply
Electrical Connections
4”
2”
LED driver
LED driver
LED driver
LED driver
To Line Fit Light
Red (+)
Red stripe (+)
White (-)
Black or blue (-)
23.0W
23.0W
23.0W
23.0W
23.0W
23.0W
Total: 161W
11.5W 11.5W
Add up total length of system
NOTE: Do not use connectors pre-filled with silicone grease/mineral base protective grease or use silicone grease to seal connections.
1
3
5
2
4
