LineFit Light-LED (LFL-LED)
Installation Guide
2
Installation
Turn off power and remove panel
from fluorescent box sign.
Push Line Fit Light into existing
fluorescent lamp holders.
Read the product labels to
determine Line Fit Light length
required to span width of
sign based on table in the
Specifications section (last page).
Old Fluorescent tube
F48T12HO
or F48T8HO
Remove old fluorescent tubes,
ballast and wiring. DO NOT remove
existing fluorescent lamp holders.
NOTE: Follow all federal and
local regulations when disposing
of neon tubing, fluorescent tubes,
transformers and ballasts.
Remove old components
Continue installing Line Fit Light
fixtures.
Orient Line Fit Light so LEDs are facing
front of sign, then pull and twist the
two endcap fittings so they align with
existing fluorescent lamp holders.
LEDs face
front of sign
Pull and twist endcap fitting
to align with lamp holder
Prior to installation, survey the site for information regarding power and accessibility inside and outside the building. Ensure that the branch
circuit supplying the existing transformer or ballast will be within the voltage ratings of the new LED power supply, and have a current rating not
exceeding 20A, or that permitted by applicable local, state, or country electrical codes (whichever is less).
If removal of the existing lighting equipment (see Step 2) eliminates the disconnect switch, as required by applicable local, state, or country
electrical codes; a new disconnect switch must be installed.
If required, the disconnect switch shall be installed by qualified personnel, in accordance with applicable local, state, and country electrical codes.
Repair and seal any unused openings in the electrical enclosure. Openings greater than 12.7-mm (1/2-in) diameter require a metal patch
secured by screws or rivets and caulked with non-hardening caulk. Smaller openings may be sealed with non-hardening caulk.
NOTE: If component 6 is necessary, refer to 32619 LFL-LED Coupler2 Line Fit Light Coupler-2nd Gen Installation Guide. If component 7 is necessary,
refer to 33125 LFL-LED Sockets LineFit Light Sockets Installation Guide.
GEF48xxxHOLED-1
New LED retrofit
Components
UL certified 18 AWG (0.82 mm
2
) supply wire
UL certified 22-14 AWG (0.33-2.08 mm
2
) wire connectors
or 22-18 AWG (0.33-0.82 mm
2
) inline/IDC connectors
End caps
Tetra
®
24 Volt Power Supply
LineFit Light-LED (LFL-LED) modules
32619 LFL-LED Coupler 2 Line Fit Light Coupler-2nd Gen (optional)
93020091 LFL-LED Sockets LineFit Light Sockets (optional)
T
C
Measure Point
The existing socket should be push-in
double contact lamp holder
Electrical grade RTV silicone.
Example electrical grade RTV silicones include:
• Momentive RTV 6700 Series Silicone Rubber Adhesive Sealant
• Momentive White Blanc RTV 162 Silicone Rubber Adhesive Sealant-
Electrical Grade
• Dow Corning 3140 - Non-Corrosive Flowable (clear)
• Dow Corning 3145 - Non-Corrosive Nonflowable (clear or gray)
• Dow Corning RTV 748 Non-Corrosive Sealant-White
1
4
2
5
3
6
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
