USA
D-Air
®
Intelligent Protection System
USA
D-Air
®
Intelligent Protection System
P. 32
6. TELEMETRIC CONTROL
The D-AIR RACING 1 I.P.S. includes an advanced telemetric control with recording of the GPS trace, capable of recording continuously for
up to 8 hours.
Monitoring of:
Lap time
Speed
Acceleration/Deceleration
Banking
Position
To use the telemetric control included with the D-air racing 1 I.P.S., download and install the software from the D-Air dedicated page in
the website
http://www.dainese.com/us_en/d-air/racing/
, under the INFO/DOWNLOAD THE DATA ACQUISITION SOFTWARE section.
After installing the software on your PC (Windows compatible) you can connect it to the D-AIR RACING 1 I.P.S. to download your
telemetric control data and make use of the various options offered by the software.
For further information on the telemetric control consult the specific documentation available on the website
http://www.dainese.com/us_en/d-air/racing/
.
7. POSSIBLE MALFUNCTIONS OF THE D-AIR RACING 1 I.P.S. AND SOLUTIONS
Table 3: possible malfunctions
Problem
Possible cause
Possible Solution
When the switch-on/switch-off button
is closed, the LED remains off
The battery is completely
run down
Charge the System for at least 3 hours.
During use, the LED starts flashing red
The switch-on/switch-off
button is open or the unit
has recorded a
malfunction
Try switching the system off and back on again. If the
problem continues, contact your nearest Authorized
Dainese Service Center or directly the Dainese Technical
Assistance Service.
After putting on the D-AIR RACING 1
I.P.S. the LED continues flashing,
alternating from green to blue without
changing to single blue flashing
The GPS signal is not
received correctly.
Try going outdoors. Under certain weather conditions or in
the presence of strong radio disturbance, the GPS signal
may be hard to receive. In these conditions, correct
operation of the System will be impossible.
If the problem continues, contact your nearest Authorized
Dainese Service Center or directly the Dainese Technical
Assistance Service.
The LED suddenly starts flashing red
and then returns to correct operation
during use.
This occurs when the
switch-on/switch-off
button is opened
temporarily.
Check that the switch-on/switch-off button is closed
correctly. If problem persists, the cables may be damaged.
Contact your nearest Authorized Dainese Service Center
or directly the Dainese Technical Assistance Service.
8. F.A.Q. (FREQUENTLY ASKED QUESTIONS)
Q: Is the D-AIR RACING 1 I.P.S. completely safe?
A: No. No protective system can protect the wearer from every possible risk or under every possible condition of use. All protective
equipment has its limits and injury and even death can occur even while wearing the D-AIR RACING 1 I.P.S.
Q: Has the system been tested by an authorized certification agency?
A: Yes. The NOTIFIED BODY UE N. 2008 DOLOMITICERT Scarl, Zona industriale Villanova
–
32013 LONGARONE (BL) participated in the
Certification process and issued the Certification (see Attachment D to this Informative Note).
0412060335 998 N.I.D-AIR RACING 1 Rev.00 LING_USA.indd 32
02/10/2015 14:47:17