Daikin Super Unit SUT00S8007-30, Operation Manual

Page: 45 / 95

PIM00424
9-3
Ground terminal
Power supply terminal block
(Screw color：silver)
Main power supply connection port φ28
Connect a
ground
cable to
the
specified
position
DANGER
●
Please use the AC power supply which is suitable for the power specifications of this product.
●
Please use cables which is suitable for the power supply capacity.
●
Please use crimp terminal at the tip of cable to connect. In addition, please use the tools adapted for crimp
terminals. Because of the crimping failure, there is a risk of wires falling out, short-circuit, heat generation
and burning.
●
Please connect the ground terminal by the D class grounding method (formerly Class 3 grounding)
●
Be sure not to connect the power supply cable to the I/O signal terminals or ground terminals. There is a risk
of electric shock and equipment damage.
CAUTION
●
The hydraulic unit incorporates an overcurrent protection function. Therefore, it does not need an
overcurrent protection thermal relay.
9.4
Connecting the I/O signal cable
1
）
Please prepare power line, crimp terminal and cable clamp.
Recommended Products
Cable Size Recommended Cable Recommended Cable Clamp
0.3 ~ 1.0mm2
(AWG16 ~ 22)
KVC-36SB 0.3 ~ 0.5mm
2
(Manufactured by
KURAMO ELECTRIC
）
Manufactured by OHM ELECTRIC
OA-W1611
Applicable Cable Shape
： Φ
9 ~
Φ
11
2
）
Connect the main power cable through the wiring hole of controller. Please use cable clamp to the wiring
port for meeting the IP54 protection degree.
3
）
Please check the specifications of each signal line, and connect the input and output signal terminal block.