Daikin Super Multi NX FDKS25EAVMB, Installation Manual

Page: 12 / 14

„ English 10
WIRING
See the installation manual supplied with the outdoor unit.
„ „ „ „ HOW TO CONNECT WIRINGS.
• Wire only after removing the control box lid as shown in the Fig.
Caution
• When clamping the wiring, use the included clamping material as shown in the Fig. to prevent outside pressure being exerted
on the wiring connections and clamp firmly.
• When doing the wiring, make sure the wiring is neat and does not cause the control box lid to stick up, then close the cover
firmly. When attaching the control box lid, make sure you do not pinch any wires.
• Outside the machine, separate the weak wiring (remote controller wiring) and strong wiring (earth wire and power supply wiring) at least
50mm so that they do not pass through the same place together. Proximity may cause electrical interference, malfunctions, and breakage.
[ PRECAUTION ]
• See also the “Electrical Wiring Diagram Nameplate” when wiring the unit for electrical power.
[ Connecting electrical wiring ]
• Power supply wiring and Earth wire
Remove the control box lid.
Next, pull the wires into the unit through the wiring through hole and
connect to the power wiring terminal block (4P).
Be sure to put the part of the sheathed vinyl into the control box.
Warning
Do not use tapped wires, stand wires, extensioncords, or starbust connections, as they may cause overheating, electrical shock, or fire.
• Make sure to let a wire go through a wire penetration area.
• After wiring, seal the wire and wire penetration area to
prevent moisture and small creatures from the outside.
• Wrap the strong and weak electric lines with the sealing
material as shown in the figure below.
(Otherwise, moisture or small creatures such as insects from
the outside may cause short-circuit inside the control box.)
Attach securely so that there are no gaps.
Inside
unit
Outside
unit
[How to adhere it]
Wire
(accessory)
Sealing material
Wiring
through hole
Wiring
Clasp
(Control box side)
(Power supply side)
Clamp
(for fixing in place)
(accessory)
∗
Remote controller wiring
Power supply wiring
Earth wire
Control box lid
Wiring Diagram
(Rear)
Terminal block (4P)
Wiring through hole
Power supply wiring
Earth wire
Power supply wiring
Earth wire
Clamp (for fixing in place)
(accessory)
Indoor PCboard
(ASSY)
1
2
3
When wire length exceeds
10m, use 2.0mm wires.
1.6mm or 2.0mm
To outdoor unit
Indoor
unit
H05VV
01_EN_3P132003-3K.fm Page 10 Wednesday, September 28, 2005 3:32 PM