English
8
Regarding outside air temperature and
heating capacity
The heating capacity of the air conditioner de-
•
clines as the outside air temperature falls. In this
case, use the air conditioner in combination with
other heating systems.
A warm air circulating system is employed, and
•
therefore it takes some time until the entire room
is warmed up after the start of operation.
An indoor fan runs to discharge a gentle wind
•
automatically until the temperature inside the air
conditioner reaches a certain level. At this time,
the remote controller displays “
”. Leave it
as it stands and wait for a while.
When the warm air stays under the ceiling and
•
your feet are cold, we recommend that you use a
circulator (a fan to circulate the air inside the
room). For details, consult your dealer.
ADJUSTMENT
For programming TEMPERATURE, FAN SPEED
and AIR FLOW DIRECTION, follow the procedure
shown below.
TEMPERATURE SETTING
Press TEMPERATURE SETTING button and
program the setting temperature.
Each time this button is pressed,
setting temperature rises 1°F.
Each time this button is pressed,
setting temperature lowers 1°F.
The setting is impossible for fan operation.
•
NOTE
The setting temperature range of the remote
•
controller is 60°F to 90°F.
FAN SPEED CONTROL
Press FAN SPEED CONTROL button.
High or Low fan speed can be selected.
The microchip may sometimes control the fan
speed in order to protect the unit.
PROGRAM TIMER OPERATION
Operate in the following order.
The timer is operated in the following two ways.
•
Programming the stop time (
•
) .... The
system stops
operating after the set time has elapsed.
Programming the start time (
•
) .... The sys-
tem starts
operating after the set time has elapsed.
The timer can be programmed a maximum of
•
72 hours.
The start and the stop time can be simultane-
•
ously programmed.
1
TIMER MODE START/STOP
Press the TIMER MODE START/STOP
button several times and select the mode
on the display.
The display fl ashes.
For setting the timer stop .... “
”
For setting the timer start .... “
”
2
PROGRAMMING TIME
Press the PROGRAMMING TIME button and
set the time for stopping or starting the
system.
When this button is pressed, the time
advances by 1 hour.
When this button is pressed, the time
goes backward by 1 hour.
3
TIMER ON/OFF
Press the TIMER ON/OFF button.
The timer setting procedure ends.
The display “
or
” changes from fl ash-
ing light to a constant light.
Refer to fi gure 4 on page [1]
NOTE
When setting the timer Off and On at the same
•
time, repeat the above procedure from
1
to
3
once again.
01_EN_3PN07520-2A.indd 8
01_EN_3PN07520-2A.indd 8
12/24/2008 2:47:03 PM
12/24/2008 2:47:03 PM
