Daikin Rotex GW-30 H12, Installation Instructions Manual

Page: 89 / 416

39
input Other values : Min. capacity modulating pump.
d Minimum rpm hot water 30 30 Settings reach 20 – 50%
E Min. flow temperature at OT (OpenTherm)
or RF thermostat 40 40 Settings reach 10 – 60°C
E. Reaction OT and RF room thermostat 1 1 0= do not respond to CH request if requested temperature is
lower than the set value par. E
1= respond to CH request with minimum flow water
temperature limited to set value par. E
2= respond to CH request with maximum flow temperature as
set in the display (on/off function)
F Start rpm CH 70 70 Settings reach 40 - 99% of the set maximum rpm
F. Start rpm hot water 70 70 Settings reach 40 - 99% of the set maximum rpm
h Max. rpm fan (* 100 rpm) 45 46 Setting reach 40 – 50
This parameter can be used to set the maximum rpm
L Legionella prevention 0 0 0 = not active
1 = legionella prevention once per week
2 = legionella prevention day to day
n Regulated flow temperature during boiler
operation (Ta)
80 80 Setting reach 60°C - 90°C
n. Keep hot water temperature at Comfort/Eco 0 0 Setting reach: 0 or 40°C – 60°C
0= reheating temperature is equal to hot water temperature
Not applicable for heating only boilers
O. Delay time CH request response 0 0 Settings reach 0 – 15 minutes
o Delay time CH operation after hot water
operation
0 0 Settings reach 0 – 15 minutes
o. Number of eco days 3 3 Settings reach 0, 1 to 10.
Not applicable for heating only boilers.
P Anti-recycling time during CH operation 5 5 Minimum switch off time on CH operation
Can be set to 0 - 15 minutes
P. Reference value hot water 0 0 Setting reach : 0, 24, 30, 36
Not applicable for heating only boilers.
q Summer mode 0 0 0 = Summer mode deactivated
1 = Summer mode to be activated by button
(code in display : Su)
2 = Summer mode to be activated by button
(code in display : So)
3 = Summer mode to be activated by button
(code in display : Et)
r Heating curve coefficient 0 0 Not active