8
English
Preparation Before Operation
Read First
1
Positioning the unit
Before installation, peel off
the tape fixing the power
supply cord to the bottom
of the unit and draw out the
power supply cord.
Power supply cord
Tape (blue)
Pointers for good positioning
• Choose a position from where airflow can reach all areas of the room.
•
Place on a stable surface. If the unit is placed on an unstable
surface, vibrations from the unit may be amplified.
• If you find that interference from the power circuit inside the unit
or cables causes interference on your TV screen or static noise
to be emitted from nearby radios or stereos, move the unit to at
least 2m away from the device.
Keep cordless phones and radio-controlled clocks away from the
unit also.
Attention
•
To avoid staining of walls, position the unit in accordance with
the positioning measurements in the illustration. However, note
that since this unit draws in dirty air, certain types of wall may be
stained even if the measurements are adhered to.
In such cases, make sure to maintain sufficient distance
between the unit and the wall.
•
When used for a long period of time in the same location, the
floor and surrounding walls may get stained as air is drawn into
air inlets near the base of the unit. It is recommended to clean
the unit periodically.
At least 100cm
away from ceiling
At least 30cm
away from wall
Air flow
At least 10cm
away from wall
At least 30cm
away from wall
About streamer discharge and active plasma ions
In some cases the air outlet may emit a slight odour as trace
amounts of ozone are generated. However, the amount is
negligible and is not harmful to your health.
This product cannot eliminate the toxic substances in
tobacco smoke (carbon monoxide etc.)
Do not use in the following places
Places exposed to direct sunlight
(Decline in the receptivity of the remote controller signal
receiver or discolouration may result)
Positions near combustion-based heating and other
high temperature devices
(Discolouration or deformation may result)
Places where chemicals and pharmaceuticals are
used such as hospitals, factories, laboratories, beauty
salons, and photographic laboratories
(Volatilised chemicals and solvents may degrade
mechanical parts and lead to malfunction)
Places with high levels of electromagnetic waves such
as near an electromagnetic cooker, speakers, etc.
The unit may not function correctly.
Places exposed to soot (conductive dust) released by
candles, aromatic candles, etc.
The performance of the filters may be impaired, causing the room
to become dirty due to the build-up of dust that is not captured.
Do not use cosmetics etc., containing silicone* near the unit.
* Hair care products (split ends coating agents, hair mousse,
hair treatment agents etc.), cosmetics, antiperspirants,
antistatic agents, waterproof sprays, lustering agents,
glass cleaners, chemical wiping cloths, wax, etc.
•
If an insulator such as silicone adheres to the needle of the
streamer unit, the streamer discharge may not be generated.
• The dust collection filter may become clogged up
resulting in reduced air purifying capacity.
Do not use an ultrasonic humidifier or similar
appliance near the unit.
The dust collection filter may become clogged up
resulting in reduced air purifying capacity.
Keep out of
direct sunlight
Do not obstruct air
inlets or air outlet
Do not expose to direct airflow
Keep TVs and radios
at least 2m away
01_EN_3P477288-1F.indd 8
9/28/2018 2:25:54 PM
