3
■
English
Before Installing the Indoor Unit
1.
Perform the following before installing the indoor unit.
1) Open the air inlet grille and the screw cover, and remove
the 7 screws.
2) Release the claws in the 3 places indicated.
3) Release the center hook and remove the front panel.
4) Release the claws in the 2 places indicated and remove
the electric component cover.
Installation Tips
1.
How to the different addresses.
1) When two indoor units installed in one room,
the two wireless remote controllers can be set
for different addresses.
PCB in the indoor addreent
2) Remove the electric component cover.
(Refer to the
BEFORE INSTALLING THE
INDOOR UNIT
.)
3) Cut the jumper JA on PCB.
Wireless remote controller
4) Cut the jumper J4
2.
In case of Ceiling suspended use.
1) Slide the switch(SW2)to “CEILING” in case of installing on the ceiling.
2 Claw
3
Air inlet grille
Screw cover
Front panel
Front panel hook
Drain pan
hook
Drain pan hook
To release the center hook
Claw
Electric
component cover
Front panel
4
1
2
* Move the front panel
in the direction of
the arrow to
remove it from the
drain pan hook.
ADDRESS JA
EXIST
1
CUT
2
J4
EXIST
1
CUT
2
J4
Wireless
remote
controller
CEILING
FLOOR
SW2
ADDRESS
01_EN_2P098794-2T.fm Page 3 Wednesday, April 14, 2004 10:50 AM
Summary of Contents for Inverter FLKS25BVMB
Page 15: ... 0408 HT 2P098794 2V M02B074C ...
