![background image](http://html.mh-extra.com/html/daikin/fxuq100mav1/fxuq100mav1_installation-manual_2460208008.webp)
6
English
Fig. 10
[THE WAY TO BLOCK AIR DISCHARGE OUTLETS]
For 2-way air discharge, outlets A and B must be blocked.
For 3-way air discharge, outlets A or B must be blocked.
1. Detach the top decorative plate from the outlets to be
blocked.
(Refer to Fig. 11)
2. Detach the flap from the outlets, too.
3. Attach the retainers to the blocking pad.
(Refer to Fig. 12)
Align the projections on the pads with the holes on the
retainers, and tape parts together with 2-sided tape.
4. After installing the blocking pads, attach the center retainer for
blocking pad and the top decorative plate.
(Refer to Fig. 13)
CAUTION
Unless blocking pads are installed as indicated, air will leak
and consequently cause dewing.
[TO CHANGE AIR FLOW RATE]
• When shipped from the factory,
the shutters on air discharge out-
lets C and D are closed so that
air flow rate is the same in all four
directions.
• Air flow rate can be changed by
sliding the shutter.
(Refer to Fig. 14)
CAUTION
Be careful not to touch the heat exchanger fins.
2-way air discharge (Refer to Fig. 15)
NOTE
• Illustrations seen from ceiling
Air intake
grille
Cornercover (×4)
Hold the indoor unit by the
hanger brackets when carrying.
Flap
Top decorative plate
Screw for top
decorative plate
Fig. 11
Bottom
decorative plate
Retainers for
blocking pad (13)(14)
(accessory)
Blocking pad (12)
(accessory)
Hole
Projection
2-sided tape
Fig. 12
Top decorative
plate
Fig. 13
Top decorative
plate
Screw for top
decorative plate
Center retainer
for blocking pad (15)
(accessory)
Center retainer for
blocking pad (15)
(accessory)
Bottom decorative plate
Blocking pad
Insert
here.
Insert
here.
Shutter
Fig. 14
C
D
A
A
B
C
D
B
Piping
area
Piping
area
Shutter
Shutter
Blocking pad
Air discharge
(Indicates drain pan.)
01_EN_3P086156-10X.fm Page 6 Wednesday, April 15, 2009 3:48 PM