![background image](http://html2.mh-extra.com/html/daikin/fxaq15auv1b/fxaq15auv1b_installation-manual_4704070008.webp)
6
English
•
Where the cool (warm) air reaches all across the room.
CAUTION
•
The indoor and outdoor units and the power supply wiring and remote controller cord must be installed at
least 1m away from any televisions or radios. This is to prevent interference with picture and sound recep-
tion. (Interference may occur even at 1m away depending on the reception quality.)
•
If installing the wireless kit, the distance of the signal sent from the remote controller might be shorter if
there are fluorescent lights which are electrically started (such as with inverters, rapid starters, etc.) in the
room. The indoor unit should be installed as far away from fluorescent lights as possible.
(2) Consider whether the place where the unit will be installed can support the full weight of the unit,
and reinforce it with boards and beams, etc. if needed before proceeding with the installation.
Also, reinforce the place to prevent vibration and noise before installing.
(3) The indoor unit may not be directly installed on the wall. Use the attached installation plate (1)
before installing the unit.
4. INDOOR UNIT INSTALLATION
•
Use only accessories and parts which are of the designated specification when installing.
CAUTION
•
Install so that the unit does not tilt to either side or forward.
•
Do not hold the unit by the horizontal flaps when lifting it. (This may damage the horizontal flaps.)
(1) Open the piping through-hole.
•
The refrigerant pipe and drain pipe can be passed out in one of 6 directions: left, bottom-left, back-left,
right, bottom-right, and back-right.
(Refer to Fig. 3)
(2) Remove the installation plate (1) from the unit and attach to the wall.
(The installation panel is temporarily attached to the unit with screw.)
(Refer to Fig. 3)
(a) Secure the installation plate (1) to the wall using either screws or bolts.
•
If using the attachment screws for the installation panel (2), attach using at least 4 screws on either
side (for a total of 8 screws (15-32 class), 9 screws (40-63 class)) of the recommended installation
cleat position on the included paper pattern for installation (3).
•
If using bolts, attach using a M8 - M10 bolt (for a total of 2 bolts) on either side.
•
If dealing with concrete, use commercially available foundation bolts (M8 - M10).
≥ 90
≥ 30
Floor
Fig. 2
Obstruction
≤ 120
≥ 2500 (from floor)
For installation
in high places.
Fig. 1
≥ 50
≥ 50
[ Space required for installation (mm) ]
4PEN494115-1A.book Page 6 Tuesday, October 3, 2017 10:51 AM