28
NOTE
Check
■
Before a long idle period
1. Operate the “FAN only” for several hours on a fine day to dry out the
inside.
• Press “MODE button” and select “FAN” operation.
• Press “ON/OFF button” and start the operation.
2. After operation stops, turn off the breaker for the room air conditioner.
3. Clean the air filter and set it again.
4. Take out batteries from the remote controller.
NOTE
• Operation with dirty filters:
(1) cannot deodorize the air.
(2) cannot clean the air.
(3) results in poor heating or cooling. (4) may cause odour.
• To order a titanium apatite photocatalytic air-purifying filter, contact the service shop
where you bought the air conditioner.
• Dispose of old filters as flammable waste.
Check that the base, stand and other fittings of the outdoor unit are not decayed or corroded.
Check that nothing blocks the air inlets and the outlets of the indoor unit and the outdoor unit.
Check that the drain comes smoothly out of the drain hose during COOL or DRY operation.
• If no drain water is seen, water may be leaking from the indoor unit. Stop operation and
consult the service shop if this is the case.
• When a multi outdoor unit is connected, make sure the HEAT operation is not being used
in other rooms before you use the FAN operation. (page 24.)
Item
Part No.
Titanium apatite photocatalytic air-purifying filter
(without frame) 1 set
KAF968B42
01_EN_3P278434-4C.fm Page 28 Thursday, August 18, 2016 11:22 AM
