14
English
NOTE
1.
All transmission wiring except for the remote controller wires must match the terminal symbol.
2.
If the unit is under 2 remote controller control, perform additional wiring of the remote controller to the
remote controller terminal board. (Refer to the section entitled SEPARATE INSTALLATION OF THE
CONTROL PANEL)
3.
If the unit is under group control, detach the remote controller cord connecting the remote controller
terminal board and the control panel. (Refer to the section entitled SEPARATE INSTALLATION OF THE
CONTROL PANEL)
•
When using 2 remote controllers, one of either the control panel or the separate remote controller
must be set to “MAIN” and the other to “SUB”.
〈
MAIN/SUB CHANGEOVER
〉
1. Insert a
screwdriver into the
recess between the upper and
lower part of remote controller
and, working from the 2 positions,
pry off the upper part.
1 2 3
1
2
3
1 2 3
1
2
3
1 2 3
1
2
3
P
1
P
2
P
1
P
2
P
1
P
2
P
1
P
2
P
1
P
2
P
1
P
2
Main power supply
Main power supply
Main power supply
Main switch
Main switch
Main switch
Fuse
Fuse
Fuse
Outdoor unit
Outdoor unit
Outdoor unit
Indoor unit
Indoor unit
Indoor unit
(NOTE 3)
(NOTE 3)
Control
Panel
Control
Panel
Control
Panel
Group control
Control by 2 Remote Controllers (controlling 1 indoor unit with 2 remote controllers)
Upper part of
remote controller
Insert the screwdriver here and gentry work off
the upper part of remote controller.
Lower part of
remote controller
01_EN_3PA60136-8Y.fm Page 14 Saturday, December 22, 2007 1:04 PM
