English
12
* If the blocking material is difficult to insert, loosen the left and right screws of the lower decoration panel and
insert it. Make sure to tighten the loosened screws again after the blocking material is fixed.
(Refer to Fig. 14)
5. INSTALLATION OF THE INDOOR UNIT
〈〈
It is easy to attach the optional parts before installing the indoor unit. Refer to also the installation
manual attached to the optional parts.
〉〉
For installation, use the attached installation parts and specified parts.
(1)
Attach the upper and lower nuts and the washers for the hanger (3) to the 4 hanging bolts.
(Refer to Fig. 15)
If the attached washer clamp (5) are used, the washer for the hanger (3) can be prevented from falling off.
(Refer to Fig. 16)
(2)
Installation of indoor unit.
(Refer to Fig. 17)
•
Insert the hangers on the air outlet
side and hang them tentatively.
•
Insert the remaining 2 hanging bolts into the hanger and fix the underside washers for the hanger (3) and
the nuts.
(3)
Check the level of the unit from 2 directions (air outlet
and
).
(Refer to Fig. 18)
Fig.14
Lower decoration panel
Lower decoration panel
Screw
Screw
< Screw location of piping >
Screw
Screw
Lower decoration panel
< Screw location other than piping part >
4
1
2
To fix hanger
Fig.15
Washer fixing method
Fig.16
Washer clamp (5)
(accessory)
Upper nut
Insert
Washer for hanger (3)
(accessory)
Nut (Field supply)
Nut
(Field supply)
Hanger
Tighten
Hanging bolt
01_EN_3P177351-6P.fm Page 12 Sunday, September 30, 2012 1:52 PM