background image

FFQ25~60B7V1B
Split system air conditioners
4PW18600-1

Operation manual

5

How to clean the air outlet and outside panels

Clean with a soft cloth.

When it is difficult to remove stains, use water or neutral
detergent.

When the blade is extremely contaminated, remove it as below
and clean it. 

How to clean the suction grill

1.

Open the suction grill

Push both knobs simultaneously and carefully lower the grille.
(Identical procedure for closing.) 

(See figure 3)

2.

Detach the suction grill

Open the suction grill 45 degrees and lift it upward. 

(See figure 6)

3.

Detach the air filter

See the figure in item No. 2 in chapter 

"How to clean the air filter" on

page 4

.

4.

Clean the suction grill

Wash it with a soft brush and neutral
detergent, and dry thoroughly.

5.

Fix the air filter

See the figure in item No. 

4

 in chapter 

"How to clean the air filter" on

page 4

.

6.

Re-attach the suction grill

See item No. 2.

7.

Close the suction grill

See item No. 1.

Start-up after a long stop

Confirm the following.
-

Check that the air inlet and outlet are not blocked. Remove 
any obstacle.

-

Check if the earth is connected.

Clean the air filter and outside panels.
-

After cleaning the air filter, make sure to attach it.

Turn on the main power supply switch.
-

The control panel display lights when the power is turned on.

-

To protect the unit, turn on the main power switch at least 
6 hours before operation.

What to do when stopping the system for a long period

Turn on FAN OPERATION for a half day and dry the unit.
-

Refer to the manual of the remote controller.

Cut off the power supply.
-

When the main power switch is turned on, some wattage is 
being consumed even if the system is not operating.

-

The remote controller display is turned off when the main 
power switch is turned off.

Disposal requirements

Dismantling of the unit, treatment of the refrigerant, oil and eventual
other parts, should be done in accordance with the relevant local and
national regulations.

NOTE

Do not use gasoline, benzene, thinner, polishing
powder nor liquid insecticide. It may cause
discolouring or warping.

Do not let the indoor unit get wet. It may cause
electric shock or fire.

NOTE

When the suction grill is very dirty, use a typical
kitchen cleaner and let it sit for about 10 minutes.
Than, wash it with water.

Summary of Contents for FFQ25B7V1B













Reviews: