Operation manual
6
FFQ25~60B7V1B
Split system air conditioners
4PW18600-1
ANNEX I
ONLY FOR AUSTRALIAN MODELS
N
AME
AND
FUNCTION
OF
EACH
SWITCH
AND
DISPLAY
ON
THE
REMOTE
CONTROLLER
1
ON/OFF BUTTON
Press the button and the system will start.
Press the button again and the system will stop.
2
OPERATION LAMP (RED)
The lamp lights up during operation.
3
DISPLAY "
" (UNDER CENTRALIZED CONTROL)
When this display shows, the system is UNDER CENTRALIZED
CONTROL.
4
DISPLAY "
" "
" "
" "
" (VENTILATION/AIR
CLEANING)
This display shows that the total heat exchange and the air cleaning
unit are in operation (These are optional accessories).
5
DISPLAY "
" "
" "
" "
" "
" (OPERATION MODE)
This display shows the current OPERATION MODE. For cooling only
type, "
" (Auto) and "
" (Heating) are not installed.
6
DISPLAY "
TEST" (INSPECTION/TEST OPERATION)
When the INSPECTION/TEST OPERATION BUTTON is pressed,
the display shows the system mode is in.
7
DISPLAY "
" (PROGRAMMED TIME)
This display shows the PROGRAMMED TIME of the system start or
stop.
8
DISPLAY "
" (SET TEMPERATURE)
This display shows the set temperature.
9
DISPLAY "
" (FAN SPEED)
This display shows the set fan speed.
10
DISPLAY "
" (AIR FLOW FLAP)
Refer to
"Air flow direction adjust" on page 7
.
11
DISPLAY "
" (TIME TO CLEAN AIR FILTER)
Refer to
"How to clean the air filter" on page 4
.
12
DISPLAY "
" (DEFROST)
Refer to
"Defrost operation" on page 7
.
13
NON-FUNCTIONING DISPLAY
If that particular function is not available, pressing the button may
display the words "NOT AVAILABLE" for a few seconds.
When running multiple units simultaneously
The "NOT AVAILABLE" message will only be appear if none of the
indoor units is equipped with the function. If even one unit is
equipped with the function, the display will not appear.
14
TIMER MODE START/STOP BUTTON
Refer to
"Program timer operation" on page 8
.
15
TIMER ON/OFF BUTTON
Refer to
"Program timer operation" on page 8
.
16
INSPECTION/TEST OPERATION BUTTON
This button is used only by qualified service persons for maintenance
purposes.
17
PROGRAMMING TIME BUTTON
Use this button for programming "START and/or STOP" time.
18
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPERATURE.
19
FILTER SIGN RESET BUTTON
Refer to
"How to clean the air filter" on page 4
.
20
FAN SPEED CONTROL BUTTON
Press this button to select the fan speed, HIGH or LOW, of your
choice.
21
OPERATION MODE SELECTOR BUTTON
Press this button to select OPERATION MODE.
22
AIR FLOW DIRECTION ADJUST BUTTON
Refer to
"Air flow direction adjust" on page 7
.
TEST
C
hr
hr
TEST
NOT
AVAILABLE
L H
5
12
4
2
22
18
17
15
16
14
8
6
7
1
3
9
11
10
13
21
20
19
hr
hr
C
NOTE
For the sake of explanation, all indications are shown
on the display in the figure contrary to actual running
situations.
