English
6
NOTE
•
Do not wash the air conditioner with hot water of
more than 50°C, as doing so may result in discol-
oration and/or deformation.
•
Do not expose it to fire, as doing so may result in
burning.
4. Fix the air filter.
(1)
Hook the air filter to a protrusion on the suc-
tion grille.
(2)
Push the lower part of the air filter onto the
protrusion at the lower part of the suction
grille, and fix the air filter there.
5. Shut the suction grille.
Refer to item No. 1.
6.
After turning on the power, press FILTER
SIGN RESET button.
The “TIME TO CLEAN AIR FILTER” display van-
ishes.
HOW TO CLEAN AIR OUTLET AND OUTSIDE
PANELS
•
Clean with soft cloth
•
When it is difficult to remove stains, use water or
neutral detergent.
•
When the flap is extremely contaminated, remove
it as below and clean or exchange it.
(For changing the flap, please contact your dealer.)
NOTE
•
Do not use gasoline, benzene, thinner, polishing
powder, liquid insecticide. It may cause discolor-
ing or warping.
•
Do not let the indoor unit get wet. It may cause an
electric shock or a fire.
•
Do not scrub firmly when washing the blade with
water.
The surface sealing may peel off.
•
Do not use water or air of 50
°
C or higher for clean-
ing air filters and outside panels.
HOW TO CLEAN THE SUCTION GRILLE
1.
Open the suction grille.
Push it downward slowly while pressing the but-
tons provided on two spots. (Follow the same
procedure for closing.)
Fig. 3
2.
Detach the suction grille.
Open the suction grille 45 degrees and lift it
upward.
3.
Detach the air filter.
Refer to “HOW TO CLEAN THE AIR FILTER”.
(Refer to Fig. 2)
4.
Clean the suction grille.
Wash with a soft bristle brush
and neutral detergent or
water, and dry throughly.
•
When very grimy
Directly apply the type of
detergent used for claning ventilation fans or
ovens, wait 10 minutes, and then rinse with
water.
5.
Reattach the air filter.
Refer to “HOW TO CLEAN THE AIR FILTER”
(Refer to Fig. 3)
6.
Reattach the suction grille.
Refer to item No. 2.
7.
Close the suction grille.
Refer to item No. 1.
START UP AFTER A LONG STOP
Confirm the following.
•
Check that the air inlet and outlet are not blocked.
Remove any obstacle.
•
Check if the earth is connected.
Might there be a broken wire somewhere?
Contact your dealer if there are any problems.
Clean the air filter and outside panels.
•
After cleaning the air filter, make sure to attach it.
Turn on the main power supply switch.
•
The display on the remote controller will be shown
when the power is turned on.
Fig. 4
Fig. 5
