12 Unit installation
Installation and operation manual
13
FAA71+100BUV1B
Split system air conditioner
3P654518-1A – 2021.03
▪
Wall insulation
. When conditions in the wall exceed 30°C and a
relative humidity of 80%, or when fresh air is inducted into the
wall, then additional insulation is required (minimum 10 mm
thickness, polyethylene foam).
▪
Wall strength.
Check whether the wall is strong enough to
support the weight of the unit. If there is a risk, reinforce the wall
before installing the unit.
▪
Air flow.
Make sure nothing blocks the air flow.
▪
Drainage.
Make sure condensation water can be evacuated
properly.
▪
Spacing
. Mind the following requirements:
≤
120
≥90
≥30
a
b
≥1800
≥50
≥50
≥90
(mm)
a
Obstruction
b
Minimum distance to the floor
NOTICE
NEVER mount the indoor unit directly on the wall. Use the
attached mounting plate for installation.
12.2
Mounting the indoor unit
12.2.1
To install the mounting plate
1
Remove the mounting plate from the unit.
▪ Remove 2 screws from class 71 or 1 screw from class 100.
▪ Push the knobs in the direction of the arrow.
▪ Remove the mounting plate.
A
b
a
b
1
1
c
2
c
2
c
2
3
B
c
2
2
2
2
3
a
b
1
c
c
c
A
Class 71
B
Class 100
a
Mounting plate
b
Screw
c
Knob
2
Choose position for piping (for bottom or side piping see
"12.2.3 To remove the pipe port cover"
14]):
a
b
c
d
e
f
a
Right piping
b
Bottom-right piping
c
Back-right piping
d
Bottom-left piping
e
Back-left piping
f
Left piping
3
Attach the mounting plate on the wall and install it temporarily.
4
Level the mounting plate (use tabs on the mounting plate).
5
Mark the centers of the drilling points on the wall using a tape
measure. Position the end of tape measure at symbol " ".
6
Finish the installation by securing the mounting plate on the
wall:
▪ When using M4×25L screws (accessory), install evenly at least 4
screws on each side.
▪ When using bolts (
Example:
for concrete wall): use M8~M10
bolts (field supply) one for each side.
INFORMATION
The removed pipe port cover can be kept in the mounting
plate pocket.
