iom-cliv-eng
www.comfort-flex.com
38
Alarm
Description
A05
This alarm indicates when the water return sensor or water return probe is damaged or broken.
A06
This alarm indicates when the water injection sensor is damaged or broken.
A10
This alarm indicates when there is a census or water flow problem.
A12
This alarm usually appears together with the A10 alarm as it depends on the configuration at which the pump was com-
missioned, otherwise the current equipment containing this controller simply has a pump configured in this case this
alarm goes together with the current pump configuration.
A15
This alarm usually appears when the water temperature does not drop due to the current cooling process. This alarm is
more of a WARNING than a serious alarm since it is simply an indicator that the equipment is not cooling and therefore
the water temperature is not dropping.
A20
This alarm indicates when the condenser temperature probe is broken or disconnected.
A21
This alarm indicates when the suction temperature sensor is broken or disconnected.
A25
This alarm indicates when the high pressure switch has suffered a change in its signal.
A29
This alarm indicates when the low pressure switch is active.
A49
When the controller has a son unit this alarm will be present if the son is disconnected.
Alarms
LOYTEC SYSTEM ALARMS
The following is a description of the alarms that are enabled in the
Cliv equipment.
High Pressure:
This alarm will be present when the high pressure switch is in
inactive mode, to review this alarm check in the parameters
section to see the current status of the switch.
Alarm number 40 check in this document the parameters menu
section for present alarms.
Low Pressure:
This alarm will be present when the low pressure switch is in
inactive mode in order to check this alarm check in the parameters
section to see the current status of the switch.
Alarm number 30 check in this document the parameters menu
section for present alarms.
Lack of Water Flow in the system:
This alarm will be present when the water flow switch is in inactive
mode to review this alarm check in the parameter section to be
able to observe the current status of the switch.
Alarm number 10 and 20 check in this document the parameters
menu section alarms present.
Freezing Water:
This alarm will be active when the water temperature is below the
cold water setpoint threshold in this case check the parameter
section to observe and be able to change this value.
Alarm number 50 check in this document the parameters menu
section for present alarms.
Broken or disconnected injection probe:
This alarm will be active when a temperature probe is broken or
disconnected, in order to evaluate this alarm check the present
alarms parameter section.
Broken or disconnected return probe:
This alarm will be active when a temperature probe is broken or
disconnected in order to evaluate this alarm review the present
alarms parameter section.
Alarm number 70, see in this document the present alarms
parameters menu section.