Remote Controller (Wireless Type)
OH08-1
68
Control Systems
Installation of the Receiver
1. Remove the corner decoration lid of the decoration panel, locating at the opposing corner of the drain
piping section. The lid will be no longer in use.
2. Remove a backside cover of the receiver.
3. Connect the wire harness (longer one) from the transmission to the connector of the printed circuit
board of the receiver.
4. Attach the backside cover of the receiver in reverse procedure to
2
.
5. Install the receiver to the decoration panel.
Field Setting
If optional accessories are mounted on the indoor
unit, the indoor unit setting may have to be
changed. Refer to the instruction manual (optional
hand book) for each optional accessory.
Procedure
1. When in the normal mode, press the
button for a minimum of four
seconds, and the FIELD SET MODE is
entered.
2. Select the desired MODE NO. with the
button.
3. Push the
“
”
button and select the FIRST
CODE NO.
4. Push the
“
”
button and select the
SECOND CODE NO.
5. Push the
button and the present
settings are SET.
6. Push the
button to return to the
NORMAL MODE.
Be sure to install the receiver to this corner.
1
2
3
4
5
Remove the corner
decoration lid.
Drain piping
section
Receiver
Remove the
fixing screw (one). Cover
Connector
(backside of
the board)
Wire harness
(longer one)
Clamp for the wire
harness shall be inside
the wall.
Connector
(backside of
the board)
Receiver
Hook the tab of
the cover to a hole
of the receiver
Cover
Tab
Receiver
Install to the
decoration
panel.
DOWN
FAN
UP
MODE
TIMER
RESERVE CANCEL
/TEST
SWING
ON OFF
SETTING
TIME
TEMP
3
2
5
4
1, 6
MODE NO.
FIELD SET MODE
FIRST CODE NO.
SECOND CODE NO.
/TEST
MODE
UP
DOWN
RESERVE
/TEST