―19―
7. WELDING PREPERATION (continued)
How to attach the hanging bracket
1. Remove hexagon head bolt (M10X16) and Nut (M8) (3pieces) and remove the wire reel
hub from the reel bracket.
2. Disassemble the wire reel hub, replace hexagon head bolt (M8X16) (3 pieces) with hexagon head
bolt (M8X25) (3 pieces) of the hanging bracket accessory and reassemble the wire reel hub to its
original condition. When reassembling, pay attention to the order and direction of parts.
3. Install the wire reel hub and hanging bracket on the reel bracket and tighten to the following
torque
so as not to loose the hexagon head bolt (M10X30), nut(M8), washer (M8) and spring washer
(M8)
(3 pieces for each) of the hanging bracket accessory in that order.
4. Adjust the wire reel hub.
M10
24N
・
m
(
245kgf
・
cm
)
M8
6N
・
m
(
61kgf
・
cm
)
Brake pad
(
Install the felt surface toward the wire reel shaft side.
)
Hexagon head bolt
(M10X55)
Cap
Brake disk
(
Install the protrusion toward
the wire reel shaft side.
)
Wire reel shaft
Hexagon head bolt
(M8X25) (3 pieces)
(Hanging bracket accessory)
Recommended tightening torque
Reel bracket
Cap
Hexagon head bolt (M8X25),
Nut (M8), washer (M8), spring washer
(M8)
(3 pieces for each)
Hexagon head bolt (M10X30)
(with washer,spring washer)
Installation hole
Hanging bracket
(option)
-
19
-