―14―
7. WELDING PREPERATION
7.1 Fitting of Wire
WARNING
●
When the wire is set on the wire reel shaft, fully tighten the cap to prevent falling.
●
In case a breakage, crack or deformation is found in the wire reel shaft or cap, do not use
but replace it.
Fitting of Wire
1. Turn the cap clockwise to loosen it.
2. Detach the cap from the wire reel shaft.
3. Mount the wire reel on the wire reel shaft.
NOTE: When installing the wire reel shaft, be sure to insert the stopper pin of the wire reel
shaft into the wire reel stopper pin hole.
4. Turn the cap counter-clockwise to tighten it.
5. Bring down the pressure handle, then raise the pressure roll holder.
6. After pulling out the wire, thread it from the pilot to outlet guide through the center guide.
7. Return the pressure reel holder first, the pressure handle.
Pressure handle
Outlet guide
Pressure roll holder
Center guide
Pressure handle
Pilot
Wire reel shaft
Wire reel stop pin
Wire reel stop hole
To loosen the cap,
turn clockwise
To tighten the cap, turn
counter-clockwise
Cap(left hand thread)
To tighten the cap, turn
counter-clockwise
－
14
－
