Parameter
Function
Interval
It is the interval of sending emails, "0" means there is no
interval for sending emails.
After setting interval, when alarm, video detection and
abnormal event trigger E-mail, the Email won't send E-mail
immediately according to the trigger of alarm signal, but send
email according to the interval of previous same event email,
which is mainly applied to the phenomenon that frequent
abnormal events generate a large number of emails and too
much pressure for email server.
Health Mail
Health mail can confirm if email link is successful according to
the test info sent by the system itself. Select the check box
and set the interval of health mail, then the system will send
email test info according to the interval.
Email Test
It is to test if email receiving and sending are normal. The
email will receive test email in the situation with correct config.
It needs to save email config info before email test.
Table 4-20
Step 4
Click "Save" to complete setting.
4.2.7
Set UPnP Parameter
It is to establish mapping relation between private network and extranet via UPnP protocol, extranet
users can have access to intranet devices via visiting extranet IP address.
Preconditions
Please make sure PC has been installed with UPnP network service.
Log in router, it is to set router WAN port IP address and make it connect to extranet.
Router enables UPnP function.
Connect the device to router LAN port and connect to private network.
Set the device "IP Address" as the private network IP of router, or select "DHCP" to acquire IP
address automatically.
Operation Steps
Step 1
Select "Setup > Network > UPnP" and the system will display the interface of "UPnP", which is shown in
Figure 4-33.
