Installation and Configuration Manual
13
Install the radar
The barrier box must be fixed firmly, and the tilt angle of the box should be less than 5°.
When installing a guardrail at one side of the lane, secure the guardrail to prevent it from moving
back-and-forth or shaking.
Do not place any objects within the radar detection range (excluding the barrier arm).
After the environment changes, calibrate the radar in time.
The radar is not suitable for scenarios where the vehicle turns in and out at a large angle. Large
angle: When the vehicle passes through the anti-smashing radar trigger area, the angle between
the vehicle and the road is greater than 30 degrees.
Installation height: We recommend that the lower edge of the radar be 0.6 m above the ground
(0.7 m above the ground when there are large vehicles.
After the 79 GHz radar (applicable to the all series of barrier gate) is installed, parameters such as
actual width, detection area bandwidth, and barrier closing time can be adjusted directly through
the configuration software or mobile app.
When there are many large vehicles, just adjust the installation height to 70 cm. You can only
configure parameters such as lane width and arm closing time on the configuration software, and
leave other parameters as default. Install the configuration software to a laptop, and then bring
the laptop to the radar installation site.
For details, see the user’s manual and FAQ of the barrier gate and radar.
