Web Basic Operations
18
Parameter Description
Network
Mode
Select the network mode of the EVS device.
Single NIC: The Network card can be used alone. You can select one
Network card to provide the HTTP or RTSP service. You need to set one
default network card (default is eth1) to request the network service started
by Email and FTP. Once the card is offline, the whole network is offline.
Fault-tolerance: In this mode, device uses bonding NIC to communicate with
the external devices. You can focus on one host IP address. At the same
time, you need to set one master card. Usually there is only one running
card (master card).System can enable alternate card when the master card
is malfunction. The system is shown as offline once all cards are offline.
Notice that all cards shall be in the same LAN.
Load balance: In this mode, device uses bonding NIC to communicate with
the external device. All cards are working now and bearing the network load.
Their network loads are general the same. The system is shown as offline
once all cards are offline. Notice that all cards shall be in the same LAN.
Link aggregation: System uses bonding NIC to realize communication
function. All binding NICs are working together and bearing the network
load. System allocates the corresponding ports to the specified switches
according to the port load setting. Once one port link is malfunction, system
stops sending out data from current port. System can calculate the new load
and specify the new port(s) to send out data. System calculates again to
specify the port(s) once the malfunction port becomes available.
EVS device only supports LACP link aggregation.
When the switch supports link aggregation and is equipped with link
aggregation, you can set the network mode to link aggregation.
NIC
Member
When the
Network Mode
is set to
Single NIC
, you can bond the current NIC to
any other one.
Management NIC does not support this function.
IP Version
You can select IPv4 or IPv6 Format. Currently both IP addresses are supported.
MAC
Address
Display the MAC address of the EVS device.
IP Address
Set the IP address, subnet mask and default gateway of the EVS device
according to the actual network planning.
Subnet
Mask
Default
Gateway
