Dahua DH-TPC-BF5300, Operation Manual

Page: 68 / 101

Dahua IR Thermal Imaging Network Camera Web3.0 Operation Manual
64
Parameter Note
Working
Period

It is to set the alarm period, it can enable alarm event only in the set time range.

There are six periods every day for setup and you must check box in front of
each period to enable it.

Select days (Sunday by default, if select all the week, then it means applying
the setup into the whole week; you can also check the box in front of the day
and make setting for some days separately).
 Click “OK” button after completing setup, go back to motion detect setting page,
click “OK” button to finish working period setup of motion detect
Note: Period setup can be done by dragging mouse while not releasing left mouse.
Anti-Dither
System only memorizes one event during the anti-dither period. The value ranges
from 0s to 100s.
Record
Check it and so when alarm occurs, system will auto record. You shall set record
period in Storage>Schedule and select auto record in record control interface.
Record Delay
System can delay the alarm record for specified time after alarm ended. The value
ranges from 10s to 300s.
Relay out
Check it to enable alarm activation output port, the system can activate
corresponding alarm output device when alarm occurs.
Alarm Delay
System can delay the alarm output for specified time after alarm ended. The value
ranges from 10s to 300s.
Send Email
If you enabled this function, System can send out email to alert you when fire
alarm occurs. User can set his email address in Network>SMTP.
Snapshot
You need to check the box here so that system can auto alarm snapshot when
alarm occurs. You shall set snapshot period in Storage>Schedule.