8. Line up the hook at the top of the external enclosure to the inside hole of the adapter block
and then push it to the end, and then tighten the three M6 screws on the adapter block firmly.
Note:
Ensure the M6 screws are tightly fixed to secure the dome to the wall mount.
9. If using the PFA120 Junction Box or the PFB300S Wall Mount mounted directly to the wall:
a. Route the cables from the rear of the wall mount through the wall.
b. Use four (4) hex screws and four (4) flat washers to secure the PFB 300S Wall Mount
to the PFA 120 Junction Box or to the wall.
10. If using the PFA 140 Power Supply Box:
a. Route the cables from the rear of the wall mount and through the hole in the cover of
the power supply box.
b. Use four (4) hex screws and four (4) flat washers to secure the PFB300S Wall Mount
to the PFA140 Power Supply Box.
c. Attach a 20-mm (3/4-in.) NPS watertight, earth-grounded conduit pipe fitting (not
supplied) to one of the opening on the bottom of the power supply box, through which
you will run power, Ethernet, and I/O cables that connect to the camera.
13
