4
Device Installation
This section details installing the camera to a solid wall or to a ceiling, in an outdoor or an indoor
environment. Note that the wall or ceiling must be capable of supporting a minimum of eight (8) times
the weight of the camera and a bracket (if used).
DO NOT connect the camera to the power supply during installation.
Figure 4-6
Warning:
For units intended to be installed outdoors: All wiring connecting to the unit must be routed
separately inside a different permanently earthed metal conduits (not supplied).
Warning:
Install external interconnecting cables in accordance to NEC, ANSI/NFPA70 (for US
application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN application) and in accordance
to local country codes for all other countries. Branch circuit protection incorporating a
20 A, 2-pole Listed Circuit Breaker or Branch Rated Fuses are required as part of the building
installation. A readily accessible 2-pole disconnect device with a contact separation of at least 3 mm
must be incorporated.
24 VAC Class 2 power supply only.
4.1
Preparing the Camera
1. Remove the camera, the mount accessories and any hardware packages from the boxes.
2. Remove the camera from the plastic wrapping and place the camera dome-end up in the foam
packaging.
3. Use the hex key to remove the three screws that secure the dome bubble to the camera housing.
4. Remove the bubble and then remove the protective foam ring surrounding the camera.
5. Insert a MicroSD card (maximum 128 GB) into the SD slot, if using local storage, located below
the lens.
6. Secure the bubble to the camera housing.
4.2
Mounting the Camera to a Wall
Use the following accessories to complete this installation:
11
