Daewoo Solar 340LC-V, Shop Manual

Page: 258 / 656

S0703010K
Page 4 Accumulator
NOTE: Pre-charge pressure is referred to as the "P1" pressure. The accumulator manufacturer’s
"P1" rated pressure should be stamped or marked on the accumulator’s rating plate.
Annual checks of actual pre-charge pressure should be made by tapping a hydraulic
pressure gauge (and 3-way adapter coupling) into the valve on the bottom of the
accumulator. When hydraulic fluid is pushed out the lower valve opening by the pressure
of the gas charge on the other side of the diaphragm - and there is no counter-pressure
from system oil - the valve button on the bottom of the diaphragm eventually seals off the
lower oil passage. Just after the needle on the gauge reaches its highest point (when there
is 0 bar (0 psi) resistance from hydraulic system pressure) pressure on the gauge will drop
sharply to zero, as the accumulator is completely emptied of oil and the diaphragm button
closes.
Record the highest gauge reading and compare to the "P1" rated pre-charge pressure on the
accumulator manufacturer’s data label. Repeat this test at least once a year to verify proper
functioning of the accumulator.
3. As hydraulic system pressure overcomes accumulator pre-charge pressure, the flexible diaphragm
begins to retract upward.
4. When system oil is at highest working pressure and the accumulator fills to maximum reserve
capacity, the flexible diaphragm is pushed up into the top of the upper chamber.
The highest working pressure is sometimes referred to as the "P3" pressure and can also be
referenced on the manufacturer’s data label on the exterior of the accumulator.
5. If system oil pressure begins to fall off or is momentarily checked or interrupted, the energy stored on
the other side of the diaphragm, in the form of compressed gas, pushes oil back out of the lower
chamber, maintaining oil pressure of the circuit.
6. With minimal system pressure, an equilibrium point may be reached in which accumulator pre-charge
pressure and hydraulic system oil pressure achieve a rough balance. In this condition a minimal
amount of oil is stored in the accumulator.
SPECIFICATIONS
Model Serial Number System
Charge
Pressure
Volume
Solar 300LC-V
S/N 1001 thru 1099
Pilot / Travel
10 kg/cm
2
(140 psi)
320 cc
(19.53 in
3
)
S/N 1100 and Up
750 cc
(45.77 in
3
)
Solar 300LL S/N 1100 and Up Pilot / Travel
10 kg/cm
2
(140 psi)
750 cc
(45.77 in
3
)
Solar 340LC-V
S/N 1001 thru 1059
Pilot / Travel
10 kg/cm
2
(140 psi)
320 cc
(19.53 in
3
)
S/N 1060 and Up
750 cc
(45.77 in
3
)
Solar 420LC-V
S/N 1001 thru 1029
Pilot / Travel
10 kg/cm
2
(140 psi)
320 cc
(19.53 in
3
)
S/N 1030 and Up
750 cc
(45.77 in
3
)