33
(1) Remove the out plate
5
and door frame
6
.
(2) Remove the microwave absorber
2
and film
1
.
(3) Remove a Spring
7
and Hook
3
.
(4) Reverse the above steps for reassembly.
4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part “A”
1) Loosen bolt and nut on top door hinge stopper,
then push the door to contact the door seal to
oven front surface.
2) Tighten bolt and nut.
(2) To reduce gap located on part ‘B’.
1) Loosen two bolts and nuts on under hinge stopper, then push the door to contact the seal to oven front surface.
2) Tighten two bolts and nuts.
(3) To reduce gap located on part ‘C’. (See Fig. 5)
1) Remove the cabinet.
2) Loosen a screw on interlock switch assembly located bottom of oven body.
3) Draw the interlock switch assembly inward as possible to engage with hook on the door bottom.
4) Tighten a screw.
(4) To reduce gab located on part ‘D’.(See Fig. 6)
1) Remove the cabinet.
2) Loosen a screw on interlock switch assembly located top of oven body.
3) “3)”and “4)” are same as step “(3)”.
NOTE : Do not attempt to remove Barrier screen “
4
” except for replacement.
NOTE : Small gab may be acceptable if the microwave leakage does not exceed 4mW/cm
2
.
HOOK
INTERLOCK
MONITOR SWITCH
MOUNTING SCREW
SECONDARY
INTERLOCK SWITCH
Fig. 5
Fig. 6
Fig. 4