Daewoo KBE-6R2SMO, Service Manual

Page: 9 / 26

8
6. DISASSEmBLY AND ASSEmBLY
WARNINg: turn off the electrical power supply to the appliance prior to servicing it. failure to disconnect the power
supply during service may result in an electrical shock or fire hazard.
Door Removal
WARNINg: Do not attempt to disengage the hinge locks on the door while it is removed from the oven.
WARNINg: the hinge springs could release, causing personal injury.
WARNINg: Do not lift or carry the oven door by the door handle.
• Open the oven door completely.
• Pull the hinge locks forward on both hinges, until they stop.
• Raise the door so that it is at a 15° angle from the front of the oven. Hold the door with one hand on each side. Lift the
door up and out.
• See page 10 for door disassembly and repair instructions.
Door Installation
WARNINg: be sure that the notch on the bottom of each hinge rests on top of the lower lip of eaCh hinge receptacle
before attempting to open the oven door. failure to do so may cause the door to fall off its hinges, resulting in personal
injury or damage to the door.
WARNINg: rotate the hinge locks toward front of the oven immediately after installation of the door. failure to do so may
cause the door to fall off its hinges, resulting in personal injury or damage to the door.
• Grasp the oven door on opposite sides and hold it at a 15° angle from the front of the oven. Slide the hinges into the hinge
openings, resting the bottom of the hinge arms on the lower lip of the hinge receptacles. Continue to hold the door at a 15°
angle with one hand while pushing in on the each of the bottom corners of the door. Push until the notch on the bottom of
each hinge slips over the lower lip of each hinge receptacle.
• Lower the door to the fully opened position.
• Rotate the two hinge locks toward the oven.
• Open and close the door completely to ensure that it is properly installed.
KBE-6R2SSS_6R2SMO(SM)_프랑스향.indd 8 2014-07-18 오후 4:34:23