At the end of every washing:
• Switch off the electricity of the power point.
• Check that both timers are set to the “O” position.
• Wipe off spillage (detergent powder,etc.), and generally wipe over the tub and base with a dry duster.
ƒR
Cleaning after use will extend the life of your washing machine. Before cleaning disconnect the power
cord from the electrical outlet.
• Remove the overflow Filter by pulling it forward.
• Wash off the lint stuck on the overflow Filter during overflowing.
• Re-install the overflow Filter: By first inserting its bottom section and then pushing the upper part firmly into place.
• Dirt maybe also collected underneath the pulsator.
• Clean out occasionally by remove the screw located in the
center of the pulsator.
• Hook the pulsator and pull upwards.
• Wash off the lint stuck on the bottom of the wash tub.
(When replacing the pulsator, make sure that the screw must be firmly tightened)
LAUNDRY GUIDE
Overflow Filter
Pulsator
CLEANING AND MAINTENANCE
Water Level
Degree of
Water
Wash
Spin
Type of Fabric
Wash load
(Volume)
Soiling
Temperature
Time
Time
Full
High
Heavy
Hot 50°C Max
Cotton and
(App. 49
\
)
Normal
Warm 40°C
Linens
Half or
Low
15 min.
5 min.
Less
(App. 35
\
)
Light
Warm 40°C
Full
High
Normal
4~5 min.
Nylon
(App. 49
\
)
Half or
Low
Light
Warm 40°C
2~3 min.
2 min.
Less
(App. 35
\
)
Delicates
Half or
High
Normal
Less
(App. 49
\
)
to Light
Warm 40°C
2~3 min.
1~2 min.
6
