4
Connection of Hoses
• Attach the water intake hose to the water inlet located at
the left-hand side of the control panel. Press fit the other
end of the hose to either a hot or cold water tap as required.
• Attach the drain hose to the drain outlet at the rear of the base.
• The drain hose should be laid flat on the ground. Water flow will be restricted if any portion of the drain
hose is raised from the ground. (NON PUMP)
• Hang up the drain hose on the edge of a sink. (PUMP)
Caution:
This unit is made of poly propylene, use water
below 50°C
Caution:
The opening must not be obstructed by carpeting when the washing machine is installed on a
carpeted floor.
WASH TIMER
RO
TAT
ION LIMIT
VALVE SELECTOR
SPIN TIMER
RO
TAT
ION LIMIT
WORLD WASH
Less than 10cm
Hose Clamp
Drain Outlet
Drain hose
A
• Sort the clothes into groups-whites, colorfast, non-colorfast, delicates, lint free, lint producer, etc., and
wash according to the
LAUNDRY GUIDE.
• Clothes with worn patches or tears should first be mended. Empty out all pockets and close all side
fasteners. Treat bad stains prior to washing.
• Ensure the drain hose is in its correct position. (See
INSTALLATION
)
• Inlet power cord plug into the power point and switch on.
!
Set the wash timer knob to position “0” and set the drain selector to the “WASH · RINSE” or “OFF” position.
@
Open the water faucet and feed water to the water level indicated inside the wash tub.
#
Put the detergent and laundry into the wash tub.
$
Set the wash time with the wash timer.
%
When washing is finished, set the drain selector to the “DRAIN” position and drain the wash tub.
HOW TO WASH
Preparation
How to Wash
(NON PUMP)
( PUMP)
