6
OPERATING INSTRUCTIONS
Emptying
• Set the valve selector knob to “DRAIN”.
• The machine will now empty.
• Set the valve selector knob to “WASH.RINSE”.
• Switch off the electricity at the power point.
CLEANING AFTER USE
• Cleaning after use will extend your washing machine. Before cleaning shut off
the power switch and disconnect the power cord from the electrical outlet, being
sure to take hold of the plug.
Filter
• Remove the filter by pulling it forward(Fig. 2).
• Re-install the filter: By first inserting its bottom section and then pushing the
upper part firmly into place.
Drain Strainer
• Remove the drain strainer from the bottom of the tub using a sharp tool such as
§^
driver.
• Wash off the lint stuck in the strainer.
• Re-install the strainer.
Pulsator
• Dirt may also collect underneath the
pulsator.
• Clean out occasionally by remove the
screw located in the center of the
pulsator.
• Hook the pulsator and pull upwards.
• Wash off the lint stuck in the bottom of
the wash tub.
(When replacing the pulsator, make
sure that screw is firmly tightened)
Figure 2.
2
1
Figure 3.
`
6
