3
INSTALLATION
Electrical Connection
• This unit is designed to operate from an adequate supply mentioned at the
rating label sticked to the rear of it.
• In case of 3-core cord: The power cord plug must be connceted to an earthed
3-pin power point within reach of the power cord.
• In case of 2 conductor power cord: Connect the grounding wire to a water
faucet etc. Make sure that the power cord is unplugged during ground work.
• Do not connect the grounding wire end to a gas tube.
• If the power cord is damaged, it should be replaced by a repair shop appointed
by the manufacturer, because special purpose tools are required.
Connection of Hoses
• Attach the water intake hose to the water
inlet located at the left-hand side of the
control panel. Press fit the other end of the
hose to either a hot cold water tap as
required(Fig. 1).
• Attach the drain hose to the drain outlet at
the rear of the base under and secure with
the clamp provided. Hang the “U” shaped
outlet of drain hose on the edge of a sink.
• The opening must not be obstructed by carpeting when the washing machine is
installed on a carpeted floor.
OPERATING INSTRUCTIONS
Preparing the Wash
• Sort the clothes into groups-whites, colourfast, non-colourfast, delicates, lint
free, lint producers, etc., and wash according to the laundry guide.
• Clothes with worn patches or tears should first be mended. Empty out all
pockets and close all side fasteners. Treat bad stains prior to washing.
Prior to Washing
• Remove the plastic cover safety from the spin basket.
• Check that wash timer knob is set to position “0” and that the valve selector is
set to “WASH.RINSE”.
• Ensure the drain hose is in its correct position (see Installation)
• Insert power cord plug into the power point and switch on.
To Wash
• Place the wash load and detergent in the wash tub. Refer to “Preparing the
Wash” and “Points to Remember”.
• Set the valve selector to “WASH.RINSE”.
• Turn the water tap on fill the tub of your washing machine to the level
recommended in the Laundry Guide.
WATER INLET
WATER INTAKE
HOSE
Figure 1.
Caution: This unit is made of poly
propylene, use a water below 50°C
`
3
