5) Install the bearing and thrust washers to
the bearing cap and apply oil to the bear-
ing and thrust washers.
- 63 -
EQM3057I
6) Install the bearing cap by matching the
cylinder block No. with the bearing cap
No.
7) Apply oil to the entire part of the bearing
cap bolts, then tighten in tightening
sequence to specified torque(30kg•m).
8) After semi-tightening both bolts evenly,
tighten them diagonally to about 15kg•m
for the first stage and 25kg•m for the
second stage respectively, then tighten
them completely to the specified torque
using a torque wrench.
9) Tighten the bearing cap in the sequence
of 4-3-5-2-6-1-7.
10) Check to see that the assembled crank
shaft turns smoothly.
3
4
5
6
7
2
1
EQM3058I
EQM3059I
3.3.6. Flywheel housing
1) Temporarily install the guide bar on the
cylinder block.
2) Apply gasket to the cylinder block.
3)
Using the dowel pin and guide bar,
install the flywheel housing and tighten
the fixing bolts in a diagonal sequence to
specified torque(12kg°m)
EQM3060I
