19
WARNING
!
6.4. Storage.
If you do not follow these steps, deposit may arise in the carburetor. This will cause starting difficul-
ties and may cause permanent damage.
6.4.1. Perform all the general maintenance that the maintenance section of your ‘User Manual’ is
recommended.
6.4.2. Clean the outside of the machine, drive axle, shield and nylon cutting head.
6.4.3. Remove all fuel from the fuel tank.
6.4.4. After all the fuel is drained, start the engine.
6.4.5. Allow the engine to run in idle until engine stops alone. This allows the fuel to be removed
from the carburetor.
6.4.6. Allow engine to cool down (about 5 minutes).
6.4.7. Use a spark plug wrench, remove the spark plug.
6.4.8. Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Slowly pull the starter rope
several times to coat internal components. Replace the spark plug.
6.4.9. Store the machine in a cool, dry place away from any source of ignition such as an oil burner,
water heater etc.
6.5. Transporting the machine.
6.5.1. When transporting the machine make sure that no fuel is allowed to leak out.
6.5.2. DO NOT allow the trimmer/brush cutter come into contact with persons, animals and proper-
ty.
