EN
EN
11
blade screw 11(Fig.4a). Remove the blade 1 along 45 ° direction (Fig.4b).
To Insert the blade 1, Be careful not to allow any foreign matter to become attached to the blade
gear and do not damage it. First Insert part of the tooth of the blade 1 into the case as shown(-
Fig.4c), then rotate the blade 1until the hole of the blade 1 is aligned to the hole of the aluminum
gearbox.Incorrect location of the blade will damage the machine. Refit the blade screw then refit the
washer 9 and the wave washer 10, at last tighten the blade nut 12.Do not over tighten.
7. Cleaning, maintenance and ordering of spare parts
Warning!Always wear protective gloves when using, adjustingor cleaning the machine.
7.1 Cleaning
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with compressed air at low pressure.
• We recommend that you clean the device immediately each time you have finished using it.
• Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep
into the device.
• A few drops of oil (e.g. sewing machine oil)will improve the cutting performance of the blades, but
never apply any grease to the blades.
Important!
Never clean the tool under running water- and particularly never with high pressure -because of the
potential danger to persons and property. Keep your cordless pruner in a dry and frost proof place.
Choose a place that children are unable to enter.
7.2 Maintenance
• To achieve good results you should keep the blades sharp at all times. The tool should be thorou-
ghly cleaned both before and after use.
• There are no parts inside the equipment which require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
• Type of machine
• Article number of the machine
• Identification number of the machine
taking to a recycling depot.
Recycling alternative to the return request:
As an alternative to returning the equipment to the manufacturer, the owner of the electrical equip-
ment must make sure that the equipment is properly disposed of if he no longer wants to keep the
equipment. The old equipment can be returned to a suitable collection point that will dispose of the
equipment in accordance with the national recycling and waste disposal regulations. This does not
apply to any accessories or aids without electrical components supplied with the old equipment.
The reprinting or reproduction by any other means, in whole or in part, of documentation and
papers
accompanying products is permitted only with the express consent of the iSC GmbH.
