10
5. BEFORE STARTING THE EQUIPMENT
5.1 Installing the battery (Fig. 2a/2b)
Press the both side of the battery pack as shown in Fig. 2a and push the battery pack into the
mount provided. When the battery pack is positioned as in Fig. 2b, make sure that the battery pack
latch in place! To remove the battery pack, proceed in reverse order.
5.2 Charging the battery (Fig.3)
1. Take the battery pack out of the equipment.Do this by pressing the both side of the battery pack.
2. Check that your mains voltage is the same as that marked on the charger rating plate. Connect
the power plug of the charging unit to a socket outlet, then insert the charging unit to battery pack.-
The red LED was always light.
3. The charging unit will end the charging automatically when the battery is fully charged(after
approx. 3~5 hours). The green LED then lights up and the red LED light out.
The battery pack can become a little warm during the charging. This is normal. If the battery pack
fails to charge, the green and red LED in the battery light up. check:
• whether there is voltage at the socket outlet
• whether there is good contact at the charging contacts
If the battery pack still fails to charge, send
• the Battery charger
• and the battery pack to our customer service center.
To ensure that the battery pack provides long service,you should take care to recharge it promptly.-
You must recharge the battery pack when you notice that the power of the cordless pruner drops.
Never fully discharge the battery pack.This will cause it to develop a defect.
6. OPERATION
WARNING: Before any work on the machine (e. g. maintenance, changing the tool, etc.) as well as
during its transport and storage, Safety lock-off in the offposition. There is danger of injury when the
On/Off switch is unintentionally actuated.
To close the blade 1(Fig. 1) activate the safety lock-off (Fig. 1 / Item 4) by pushing it forward and
pressing the ON/OFF switch (Fig. 1 /Item 3) at the same time. To open the blade 1, let go of the
ON/OFF switch(Fig. 1 / Item 3).
Never operate the machine in an awkward posture.This may cause serious injury.
Keep your free hand away from the cutting area. Never touch the blades. They are very sharp and
you may cut yourself. Always wear protective gloves while pruning.
6.1 Changing the blade(Fig.4a-4c)
Warning! Remove battery from pruner before Changing the blade.
Always wear protective gloves when Changing the blade.
Never attempt to operate the machine without the blade, spacer or screw correctly secured
to prevent damage to the machine.
To remove the blade 1, Use a Hexagon wrench socket key (not provided) to remove the blade nut 12
which secures the blade. Remove the blade wave washer 10 and the washer 9 then remove the
