Daewoo D1146, Maintenance Manual

Page: 78 / 147

D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
74
Printed in Jan. 2001 PS-MMA0415-E1A
shaft, then assemble the oil seal using an oil seal fitting jig.
3.3.8. Flywheel
z
Installation of flywheel ring gear
With a gas burner, heat the ring gear
evenly until heat expansion takes place,
then install it using a hammer.
CAUTION :
Do not allow the temperature of the ring
gear to exceed 200
°
C (390
°
F).
z
By means of mandrel, assemble pilot
bearing to the flywheel.
z
By means of mandrel, press in the wear
ring at the backward face.
z
Install a guide bar into a bolt hole on
the crank shaft, and lift the flywheel to
align the dowel pin with the pin hole on
the flywheel for temporary assembly
operation.
z
Coat the adhesive (#271 Loctite) over the
assembling bolts and install bolts in the
remaining holes. After that take out the
guide bar, then install a bolt in the hole
where the guide bar had been inserted.
z
According to the order of tightening
tighten the fixing bolts using a torque
wrench in a diagonal sequence to
wear ring
ring gear
G1031
M1122