Daewoo D1146, Maintenance Manual

Page: 66 / 147

D1146/D1146TI/DE08TIS
MAINTENANCE MANUAL
62
Printed in Jan. 2001 PS-MMA0415-E1A
Compare the two values obtained
through measurement of connecting
rod bearing inside diameter with the
outside diameters of crankshaft pins
to determine the oil clearance.
Standard Limit
0.034
∼
0.098 mm
0.25 mm
z
If the clearance deviates from the
specified range, have the crankshaft
journals and pins ground and install
undersize bearings.
3) Oil clearance between crankshaft and bearing (Method 2 : plastic gauge)
z
Assemble the crankshaft on the
cylinder block and put plastic gauge
on the journal and pin of crankshaft
and then after assembling bearing
cap, tighten the bolts at the specific
torque. Again after disassembling
the bearing cap by removing the
bolts, take out the flatted plastic
gauge and measure the width of
plastic gauge by means of plastic
gauge measuring scale. This is the
oil clearance.
z
The oil clearance too can be
measured in the same manner