daewon DIB-N800 Series, User Manual

Page: 8 / 20

1. Remove the seat from the existing toilet
Release the nuts and then remove the seat and cover.
Keep the removed seat, cover and nuts in a a proper
place in case of using them again.
2. Shut the supply off, and empty the tank completely
Connect with the cold water supply only.
Failure to do may result in flooding, leaking or damage
to the product when the hose is disconnected.
3. Disconnect the toilet hose and install the T-valve
You may use the bucket to catch the residual water
from the hose.
Check and ensure the rubber washer sits flat inside of
the T-valve.
4. Install the catch plate
Wet the rubber anchor bolts with water and firmly
insert them all the way down into the mounting holes
on the top of the toilet.
Place the mounting plate over the rubber anchor bolts
on the toilet.
Place the brackets flat side down on the mounting
plate over the rubber anchor bolts. Insert metal
mounting bolts through the holders and rubber anchor
bolts; use a screwdriver to screw in the mounting bolts
and tighten.
If the toilet bowl is not suitable to use mounting
anchor bolts, contact the local dealer where you
bought your product for more assistance.
Before installation Product Installation
Do not plug the product in until the unit is completely installed.
Caution
Read the manual first before installation.
Check whether the toilet to be installed is suitable for the installation
Toilet size, mounting hole spread, shutoff valve installed, Space for T-valve, flexible hose
installed, etc. For this, contact the local dealer where you purchase your bidet seat for
special assistance.
Prepare the standard screwdriver and wrench in advance.
Teflon tape may be needed between plumbing connections
Every product is tested with pure water during production to ensure the highest quality
and performance. It is normal to find a small amount of residual water drops or moisture
on the product.
14 15
Insert the deodorizer filter into the cartridge hole.
5. Insert the deodorizer filter
※ Applicable models only