Maintenance and safety instructions
Once a year, please check the maintenance by a service center agent or
distributor.
7
7-1. Test Methods and Calibration
7-2. Explanation of each test
1) Connect AC cord while CH1, CH2 air sockets are fully connected with 4 cuffs.
2) Turn on power switch ON/OFF located at the back of the device.
3) Press Alarm Power Button together and go to Maintenance mode.
4) Press Power button with long key to quit Maintenance mode.
- DTS-3000 uses both Main board and Sub board in general.
Main board : It is mainly controls Drive that manipulate LCD display, Button input
control, LOP control, SD DATA SAVE.
Sub board : It is the board that will proceed for the order coming from Main board
after giving command using UART communication.
* If there is communication error between Main board and Sub board, Sub board
version won’t be shown. In this reason user can notices if the data communicates
w or not.
7-2-1. Version verification
33
UserManual_DTS-3000_170223_인증용.indd 33
2017-02-23 오후 2:06:08
