5
Verifying the Operation
Connect power to the electrical receptacle.
Operate the appliance as outlined in the Use &
Care Manual, that accompanied this product.
Connecting the Electrical Power
WARNINGS:
1. Verify that the proper electrical
power supply has been
provided.
2. Verify that the electrical supply
matches the ratings found on
the appliance data plate before
proceeding.
3. Be certain that power to the
electrical receptacle has been
disconnected, then plug the
appliance into the electrical
receptacle.
4. This appliance must be
connected to a grounded,
metallic, permanent wiring
system. Alternatively, a
grounding conductor should
be connected to the grounding
terminal or lead on the
appliance. Failure to do so
may result in an electrical
shock hazard.
Three-Prong Plug
Three-prong grounded receptacle
and cover plate
Grounding Instructions
The appliance is supplied with a four (4) foot
long power cord terminated by a three-prong
plug. The appliance power cord is intended to be
plugged directly into a wall-mounted electrical
receptacle. The correct voltage, frequency and
amperage must be supplied to the electrical
receptacle from a grounded, single phase circuit
that is protected by a properly sized circuit
breaker or time-delay fuse. The required voltage,
frequency and amperage ratings are listed on the
product data plate (located on the bottom of the
chassis on the left side).
Slide Product Into the Cutout
• Carefully, slide the unit into the
opening. Be careful not to entangle
power cord.
• Make certain that the chassis is even
with the adjacent cabinetry.
• Check again to be sure the unit is
level.
Leveling
• Use an adjustable wrench to turn the
leveling legs and raise or lower the
product.
• Adjust carefully; the product should
be level and plumb with cabinetry,
and should align with adjacent
toekick height.
Turn Right to Lower
Turn Left to Raise
If you did not reverse the door swing:
• Select the hinge cover marked “R” or
“L”, depending on door swing.
• Peel backing off the tape inside the
decorative hinge cover. Press and
snap into position.
• Snap the screw hole cover into place
on the opposite side.
5. Do not use an extension cord
with this appliance. Such use
may result in fire, electrical
shock, or other personal
injury.
6. Do not install a fuse in the
neutral or ground circuit. A
fuse in the neutral or ground
circuit may result in an
electrical shock hazard.
Summary of Contents for Wine Steward/Beverage Cooler
Page 7: ...6 NOTES...
