Dacor Wine Steward/Beverage Cooler, Installation Instructions Manual

Page: 5 / 8

4
Staining Wood Drawer Fronts
The drawer fronts are unfinished maple wood.
During use, oil from hands may accumulate and
stain the wood.
• The drawer fronts may be stained and
sealed to match adjacent cabinetry.
The tinted glass will make the stained
wood appear darker. A true color
match can be seen only when the
door is opened.
• Apply the stain and sealer according
to the manufacturer’s instructions. To
avoid unpleasant odor, keep the door
open to ventilate and allow
the stain/sealer to dry completely
before using
Reverse Door Swing
NOTE:
Skip this step if door swing suits
the installation.
Parts Included:
• Top left case hinge
• Bottom left case hinge
• Left and right side decorative hinge
cover
• Decorative hinge screw hole cover
• Torx® driver bit
Tools Required:
• Phillips screwdriver
• Electric drill
Remove the door:
• Flatten the shipping carton to use as a
pad.
• Remove the 2 screws and the toekick.
Set aside the screws and toekick for
final installation.
• Use the supplied Torx® bit and
electric drill to remove the 3 screws
holding the top case hinge. Lift off the
hinge. (Screws will be used to install
the new hinge.)
• Lift the door off the bottom case
hinge.
• Remove the bottom case hinge pin
and bracket.
Rotate the door:
• The handle will be on the right side of
the door; hinges will be installed on
the left side of the case.
• Remove the door stop and cam riser
on the original bottom right side of the
door.
• Remove the fill plug on the top right
side of the door.
• Turn the door over and reinstall the fill
plug on the new left side.
Reinstall the door:
• Install the original door stop and cam
riser onto the bottom left side of the
door.
• Install the new supplied bottom case
hinge pin and bracket onto bottom left
side.
• Place the door onto the bottom case
hinge.
• Install the supplied left-hand top case
hinge with the 3 original screws.
• Select the hinge cover marked with an
“L”.
• Peel backing off the tape inside the
decorative hinge cover.
• Press and snap the hinge
cover into place.
• Snap the screw hole cover into place
on the opposite side.
NOTE:
Check to be sure screws are tight
and that the door is straight and
does not sag. The door should
swing freely.
Install Covers
Install
3 Hinge
Screws
Remove
Top Hinge
Remove
Hinge
Hinge
Pin and Bracket
Door Stop
and Cam Riser
Applying Dacor Nameplate
Follow instructions on the back page for
installation of the Dacor nameplate.
Install Toekick
The toekick has a cutout on the left and right
sides. Remove the plug on the left side and
reinstall on the right side.
• Install original screws and spacers.
Install screws through the spacer
standoff, toekick and into the base as
shown.
Move Fill
Plug to
Right Side